Flight Termination System
The IMC Flight Termination System (FTS) is a completely redundant and transportable solution. It includes an exciter, transmitter, RF power amplifier, antenna, and recording unit. It transmits necessary codes (IRIG 313-01 tones or digital secure FSK codes) to check, monitor, arm, and destruct a missile or UAV in flight equipped with a FTR (Flight Termination Receiver). The system is capable of controlling up to 4 remote units in parallel.
A GUI management system is included for configuration of each unit. The system is compatible with IMC Flight Termination Receivers or any other standard receivers that comply with IRIG standards.
| Specification | Range |
| Carrier Frequency | 400MHz – 450 MHz (configurable) |
| Carrier Frequency Tolerance | 20 (confgiure up to 6 per command ) |
| Output Power | Wideband FM |
| Multi Tragets | Up to 4 simulatinus |
| Tone output signal delay | < 5 milliseconds |
| Prime Power | 115-230 VAC |
| Remote Activation | remote panel command buttons |
| Remote Programming | RS-232 interface – using supplied GUI |
| Fault Detection | RF output power, tone monitor |
| Specification | Range |
| Carrier Frequency | 400MHz – 450 MHz (configurable) |
| Carrier Frequency Tolerance | 20 (confgiure up to 6 per command ) |
| Output Power | Wideband FM |
| Multi Tragets | Up to 4 simulatinus |
| Tone output signal delay | < 5 milliseconds |
| Prime Power | 115-230 VAC |
| Remote Activation | remote panel command buttons |
| Remote Programming | RS-232 interface – using supplied GUI |
| Fault Detection | RF output power, tone monitor |
IRIG 313-01 complaint
Automatic 1:1 redundancy
Command tone verification
Fully configurable using GUI (frequency, tones, commands, etc.)
Operational from main unit or up to 4 remote units.
Remote Control unit (optional)
Switch Guards on all toggle switches
- Air transportable in Operational Transit Case
Main command and control unit (MCCU)
Remote command and control unit (RCCU)
Power Amplifier – 50W – 500W
Monitoring and logging unit
Supported GUI management system
3 rack units high, shock mounted – Exciter/Transmitter
3 rack units high, shock mounted – Power amplifier
1 rack units high, shock mounted – Recording unit
